Cleaning The Soleplate - T-Fal AQUASPEED Serie Manual De Instrucciones

All manuals and user guides at all-guides.com
1800110948-AQUASPEED ULTRACORD USA CAN

Cleaning the soleplate

• While the soleplate is still slightly warm, clean it by wiping over it with
a damp non-metallic cloth.
• Unplug the iron and wait for the soleplate to cool down.
• Close the Ultracord System and lock it by positionning the ring
• Empty the water tank and set the steam control to "0". A little water
• Wind the cord around the heel at the back of the iron. Store the iron on
If there is a problem
PROBLEM POSSIBLE CAUSES
Water drips from the The chosen temperature is too
holes in the soleplate. low and does not allow for the
formation of steam.
You are using steam while the iron is
not hot enough.
You are using the Steam button
There is too much steam.
You have stored the iron horizontally,
without emptying it and without
setting it to "0".
Brown streaks come You are using chemical descaling
through the holes in agents.
the soleplate and
You are not using the right type of
stain the linen.
water.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
The soleplate is dirty You are ironing with an inappropriate
or brown and can setting (temperature too high).
stain the linen.
Your linen has not been rinsed
sufficiently or you are using starch.
There is little or no The water tank is empty.
steam.
The anti-scale valve is dirty.
Your iron has a build-up of scale.
Your iron has been used dry for too long. Carry out a self-clean.
The soleplate is You have placed your iron flat on a
scratched or metallic rest-plate or ironed over a zip.
damaged.
Water is running out You have not closed the water tank
of the water tank flap properly.
flap.
Steam or water The steam control is not set to the
leak from the iron position.
as you finish filling
the tank.
The spray does not There is not enough water in the water
spray. tank.
For all other problems or questions, please contact our Consumer Service Department at 1-800-395-
8325 or visit us at www.t-falusa.com. Or in Canada at 1-800-418-3325 or visit our website at www.t-
fal.ca. You may also contact an approved Service Center, please visit our website for their contact
information.
8
24/09/07
indicator (depending on model) onto
may remain in the tank.
its heel – fig.16.
too often.
"0"
15:18 Page 8
Never use abrasive or
aggressive products
on the soleplate.
Storing your iron
.
SOLUTIONS
Position the thermostat in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of the
Steam button.
Reduce the steam.
See the section "Storing your iron".
Do not add any descaling agents to the water
in the water tank.
Perform a self-cleaning operation and
consult the section "What water to use?"
Perform the self-cleaning operation and clean
the soleplate with a damp sponge. Vacuum
the holes of the soleplate from time to time.
Clean the soleplate as indicated above.
Select the appropriate setting.
Clean the soleplate as indicated above.
Always spray starch onto the reverse side of
the fabric to be ironed.
Fill the water tank.
Clean the anti-scale valve.
Clean the anti-scale valve and carry out a self-
clean.
Always set your iron on its heel.
Check that the water tank flap is locked
properly (until your hear a "click").
Check that the steam control is set to the
"0"
position.
Fill up the water tank.