T-Fal AQUASPEED Serie Manual De Instrucciones página 6

All manuals and user guides at all-guides.com
1800110948-AQUASPEED ULTRACORD USA CAN
Fill the tank up to
• Check that the Ultracord system is properly locked.
the "MAX".
• Unplug your iron before filling it.
Never fill the
• Set the steam control to
appliance by
• Take the iron with one hand and tilt it slightly, with the nose of the
holding it directly
under the tap.
• To open the flap of the water tank, push the button – fig.2.
• Fill the tank up to the
• Close the flap of the water tank, until it clicks into place.
Use
Adjust the temperature and the steam
• Set the thermostat control – fig.4, referring to the table below.
• The thermostat light comes on. It will go out when the soleplate is hot enough – fig.5.
FABRIC
LINEN
COTTON
WOOL
SILK
SYNTHETIC
(Polyester, Acetate,
Acrylic, Nylon)
RECOMMENDATIONS
• Your iron heats up quickly: so begin by ironing fabrics that are ironed
at low temperatures first, then go on to those requiring a higher
temperature,
• If you turn down the thermostat, wait until the thermostat light
comes back on before beginning to iron again,
• When ironing fabrics with mixed fibres, set the ironing temperature for
the most delicate fibre. For delicate fabrics we recommend testing the
fabric first on an inconspicious place eg (inside the hem).
Make sure that
• Whether steam or dry ironing, you are able to use the spray button to
there is water in the
tank before using
this button.
Obtain more steam
• Press the Steam button
• Wait a few seconds between each shot before pressing the Steam
button again.
Hold the iron a few
• Hang the garment on a hanger and hold the fabric slightly pulled
centimetres from the
fabric to avoid
burning delicate
fabrics.
• Set the thermostat control to
• Press the Steam button
6
24/09/07
"0" – fig.1.
soleplate pointing down.
"MAX"
POSITION OF
THERMOSTAT CURSOR
MAX
•••
••
•
dampen laundry to remove stubborn creases –
fig.7.
from time to time –
straight with one hand.The steam is very hot, so you should always do
this with the garment on a hanger – never iron clothes which someone
is wearing.
repeatedly –
top to bottom – fig.9, wait a couple of seconds between each use of
the button.
15:18 Page 6
Filling the water tank
line – fig.3.
STEAM SETTING
POSITION
0
= STEAM ZONE
In order to avoid
water dripping from
the iron onto the
linen:
- Turn off the steam
when ironing silk or
synthetic fabrics.
- Set it at the
minimum position for
wool.
Spray Function
fig.6.
Vertical steam ironing
"MAX" – fig.8.
fig.7 moving the iron from