Installation Procedure - Bosch NEB 36 Manual De Instrucciones

Installation Procedure

1) Prepare Power Supply
2) Seal the Cooktop with
Foam Tape
English 4
All manuals and user guides at all-guides.com
• 40 Amp circuit breaker
• 240 Volt, 4 Wire, 60 Hz / 208 Volt, 4 Wire, 60 Hz
Connect only to a 4-wire 120/240 or 120/208 volt AC system. The neutral is
required for the operation of this appliance and an independent ground is
required.
WARNING:
cooktop, switch power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
• Install a junction box (not supplied), below the counter top within 3 feet (91.4
cm) of flexible conduit (supplied) located at the left rear corner of the cooktop
rough-in box.
• Plan the installation of the unit so the location of the junction box is within 3
feet (91.4 cm) of the left rear of the cooktop bottom.
• The junction box must be accessible from the front of the cabinet.
Foam tape is provided to seal the cooktop edges to the countertop. Seal the cook-
top with the foam tape as follows:
Important: Apply the tape starting at a middle point of any edge of the cooktop.
Do not start at any corner of the cooktop.
1. Turn cooktop upside down.
2. Start at the middle of the front, back, or either end of the cooktop and apply
the one continuous piece of tape approximately 1/16" (1.6 mm) from the glass
edges. Use tape around the entire glass perimeter.
3. Overlap the end of the tape with the start of the tape and cut through the cen-
ter of the overlapping pieces with the scissors to ensure the ends of the tape
create a tight-fitting butt joint.
To avoid electrical shock hazard, before installing the
Conduit
(approx 3 ft.(91.4 cm))
12"
(30.4 cm)
(approx)
"j" Box
Figure 3:
Junction Box Installation