BE QUIET! DARK POWER PRO Manual Del Usuario página 26

3 . 1 . C O M P AT I B I L I T Y
The be quiet! power supplys featured Dark Power PRO series are compatible with current popular power supplys and
4 . I N S TA L L AT I O N O F Y O U R N E W P O W E R S U P P LY
Please read the point „Warnings and safety notes" before you begin the installation.
: To install the power supply in your PC, you will require a screwdriver. Only use the screws delivered with
the adapter because they have the provide the correct thread
1. Separate your PC from all available sources of electricity and carefully remove all cables attached to the PC.
2. Open the PC case and if necessary, observe the manufacturer instructions.
3. Remove all connectors from the mainboard and all additional components such as FDD, HDD or optical drives.
Please make sure that no connectors from the old power supply are connected to a component.
4. Now unscrew the screws on the backside of the power supply and carefully remove them. When doing this,
make sure that no cables get caught on components and thus, become damaged.
1. Place the new power supply in the space provided in the case and screw it into the backside with the four
screws included with the delivery. Do not use excessive force to do this.
2. Place the 20/24 pin into the intended connector on the mainboard. If you have a 24 pin connection, then place
the remaining 4 pins in the correct position before you stick the connector in the socket. When using a 20 pin
3. Now stick the 4 pin connector, also called the P4 connector, into the provided socket on the mainboard. This
connector is will provide your CP in the future with additional electricity.
as of 650W). You connect these into the socket on the mainboard. Some mainboards also require an additional
6 pin EPS connector. If this is the case, also connect this connector.
: Please observe the your mainboard manufacturer instructions when connecting the EPS connector . Not
all mainboards dispose of these connections.
CABLE MANAGEMENT:
cable salad is avoided and the case is kept tidy.
A special advantage is the now unchecked draft through the case. Disruptive cables prevent the air from traver
management.
Note:
only a very low resistance. Should problems however arise, never alter the connectors and cable connections your
self. This can possibly cause permanent damage to the power supply and the other components as well as being
grounds for a loss of warranty.
26