Front Cover - Franke 3590040 FSBS 6001 N ID XS A+ Instrucciones Para El Uso E Instalacion

Replacing Freezer Door
Insert the water tube into the hole of
the bottom hinge pin first (Dispenser
Models Only). Insert the bottom of
freezer door into the bottom hinge pin.
en
Turn the hinge fastener tightly to the
end. Connect harness wirings and
screw ground wire.
Replacing Refrigerator Door
Insert the bottom hole of refrigerator
door straight to the bottom hinge pin
All manuals and user guides at all-guides.com
Insert the bottom hole of freezer door Let the top of door close to the
straight to the bottom hinge pin. cabinet and insert the top hinge pin
to the top hole of freezer door. (Insert
the back of hinge to the groove of
protrusion first, then front to the top
hole of door.)
Insert the water tube far into the
coupling.
(Dispenser Models Only)
Let the top of door close to the cabinet Turn the hinge fastener tightly to the
and insert the top hinge pin to the top end. Connect harness wirings and
hole of freezer door. (Insert the back of screw ground wire. Click and screw
hinge to the groove of protrusion first,
the top hinge cover.
then front to the top hole of door.)
44
Refrigerator Leveling & Door
Adjustment (If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
In case freezer door is lower than refrigerator door...
Insert a screw driver (flat tip) into a groove of the left wheel (bottom of freezer) and
turn it clockwise until the door is balanced.
(clockwise to raise freezer door ; counterclockwise to lower)
In case refrigerator door is lower than freezer door...
Insert a screw driver (flat tip) into a groove of the right wheel (bottom of refrigerator)
and turn it clockwise until the door is balanced.
(clockwise to raise refrigerator door ; counterclockwise to lower)

Front Cover

After installation and/or door leveling, fasten front cover with screws.
(Remove the screws on the front bottom panel first. Click and screw the cover)
The front of refrigerator needs to be higher just a little than the back for easy door closing, but if
the wheel is raised too much for door balance, i.e. front of refrigerator is higher than the back, it
Caution
can be difficult to open thedoor.
45
en