Idiomas disponibles
Idiomas disponibles
5. Fully extend the Extension Pole and secure it by tightening
the Height Adjuster.
NOTE: If the Extension Pole is not readily visible, look
inside the Base Pole (where it is located) and pull it
completely up.
6. Remove the rear grill nut and mount the rear grill. Make
certain that the holes in the grill fit over the prongs
protruding from the motor housing. Install the grill nut and
hand tighten.
7. Insert the fan blade onto the motor shaft and make sure that
the fits as far back on the shaft as possible. Tighten the
blade spinner into place to secure the blade onto the shaft.
8. The blade spinner is tightened by turning
counter-clockwise.
9. Mount the front grill onto the rear grill with all clips open.
Then securely close the clips so that they
hold the grill firmly and evently together.
10. Attach the Front Guard to the Rear Guard:
1) Pull the Clamps on the Front Guard up.
2) Place the slot in the Rim Hook (at top
of Front Guard) onto the uppermost
prong of the Rear Guard and snap the
Rim Hook in place.
3) Push each Clamp down to secure.
11. Place the assembled fan on a flat, level, stable surface.
OPERATING INSTRUCTIONS:
1) Place the fan on a safe, flat surface where it will not fall or
be pulled by the cord.
2) To adjust height, loosen the Height Adjustment Control
Collar; adjust to the desired height and retighten.
3) Control the direction of the airflow by firmly holding the
switch box in one had and pushing the fan grille back to tilt
up or by pushing it forward to tilt down.
4) To make the fan oscillate, push down on the oscillating
knob located on the top of the motor housing. To stop the
fan from oscillating, pull up on the oscillating knob.
5) Plug into an electrical outlet (120V AC, 60Hz).
CONTROL PANEL INSTRUCTIONS:
1. Make sure the Fan is properly assembled. Plug the Power
Cord into a standard 120-volt AC electrical outlet.
2. Insert 2 AAA batteries into remote control hand unit.
3. SPEED/ON: To turn the Fan on/ change speeds by
pressing the SPEED/ON.
4. MODE: To set the mode of natural wind/ sleep wind/
normal wind by pressing the MODE.
5. TIMER: To set time from 0.5—7.5h, press timer each time
can set 0.5h cumulatively.
To select the desired length of operation, program the fan to
switch off up to 7.5 hours later in increments of 0.5 hour.
All manuals and user guides at all-guides.com
After setting the timer, the indicator light will illuminates
the desired length of time on the fan's control panel. After
the predetermined length of time has passed, the fan will
automatically switch off.
6. OFF: To turn off the fan by pressing OFF.
NOTICE: To avoid product damage, press only one
Button at a time.
7. To oscillate the Fan, push down on the Oscillation Control.
8. To stop oscillation, pull up on the Oscillation Control.
9. To adjust the tilt angle, tilt the Motor Housing up or down
until it clicks into place.
10. To adjust Fan height, loosen the Height Adjuster, lower or
raise the Extension Pole, and retighten the Height Adjuster.
11. To turn the Fan off, press the OFF Button and unplug the
Power Cord from the electrical outlet.
WARNING: Always unplug the Fan when not in use and
before leaving it unattended.
12. The controls button located on the fan panel are exactly the
same as remote control hand unit, that means you can
operate the fan by either the remote or at the panel switch
itself. This fan offers you standard 3 speed choice options.
