Torin BIG RED 1500-LB El Manual Del Propietario página 9

TO RAISE JACK
1. Position the jack near desired lift point.
2. Set the Parking Brake on the vehicle.
3. Refer to the vehicle manufacturer owner's manual
to locate approved lifting points on the vehicle.
Position the jack so that the saddle is centered
and will contact the load lifting point firmly.
4. Close the release valve by turning it clockwise
until it is firmly closed.
5. Pump the foot pedal to raise the load.
A. Shown in the image is left side of the safety arm.
B. When the load is fully raised, check that the
safety arm engages the raised tabs of the frame.
This will prevent accidental lowering.
5. Pump the foot pedal to raise the load.
A. Shown in the image is left side of the safety arm.
B. When the load is fully raised, check that the
safety arm engages the raised tabs of the frame.
This will prevent accidental lowering.
All manuals and user guides at all-guides.com
Release
valve
Foot pedal
Safety Arm
6. Before raising the vehicle double check and
verify the saddles are centered and also have full
contact with the lifting point.
7. Pump peddle to lift until saddles contacts load.
Continue to pump the jack to lift the vehicle to
the desired height. Verify that both safety arms
are engaging the frame to support the load.
After lifting, additional support the load with
appropriately (Use the tie-down mounting points
with tie-down straps to secure vehicle) before
working on the vehicle. Vehicle must be stable
before any work begins.
CAUTION: NEVER WIRE, CLAMP OR
OTHERWISE DISABLE THE LIFT CONTROL
VALVE TO FUCTION BY ANY MEANS
OTHER THAN BY USING THE OPERATOR'S
HAND. USE THE HANDLE PROVIDED WITH
THIS PRODUCT OR AN AUTHORIZED
REPLACEMENT HANDLE TO ENSURE
PROPER RELEASE VALVE OPERATION.
9