SAFETY
Always follow safety precautions when installing and operating this jack. Keep all decals on the unit clean and
visible. Before proceeding ensure that you fully understand and comprehend the full contents of this manual.
Failure to operate this equipment as directed may cause injury or death. The distributor is not responsible for
any damages or injury caused by improper use or neglect.
• This equipment is designed only for lifting motorcycles.
• Do not move or dolly the vehicle while load is supported or raised.
• The vehicle must be supported after lifting immediately by appropriate means.
• NEVER go under a vehicle that is not supported with appropriately rated support stands.
• Use wheel chocks or other blocking device on opposing wheels before using support stands.
WARNING!
Always use Jack Stands!
DO NOT USE wood blocks or any other non-approved load sustaining devices. The manufacturer only
warrants loads to be sustained by jack stands that meet current ASME standards.
DO NOT USE wood blocks or any other non-approved lifting devices for a means of lifting with the jack and or
load being raised. Failure to head these warnings may cause injury or death.
SAFETY MARKINGS
WARNING!
1. Study, understand, and follow all instructions before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces, with less than 3 degrees of slope.
4. Lifting device only. Immediately after lifting, support the vehicle with appropriate means.
5. Do not move or dolly the vehicle while on the equipment.
6. Lift, mount, and support only on areas of the vehicle as specified by the vehicle manufacturer.
7. If equipment is supplied with a Secondary Safety Lock Mechanism, engage before applying a load.
8. Center load on platform or saddles prior to lifting.
9. Immediately after lifting load, ensure lift mechanical load-holding (safety lock mechanism) means is
engaged.
10. Assure load is centered and secured to mounting attachments.
11. Before moving, lower the load to the lowest possible point and remove vehicle.
12. Secure load with appropriate restraint device.
13. Lock the wheels/casters after vehicle has been raised and stabilized.
14. Off-center loads may cause a load to shift/rotate/tip in either direction. It is important to stabilize off-center
loads by appropriate means.
15. Verify that wheels/casters are locked before beginning working on vehicle.
16. Do not get under or allow anyone under the vehicle, until vehicle has been supported by appropriate
means.
17. When lowering equipment and vehicle, it is important to release the rotational locking devices slowly and
carefully.
18. Be aware of all surroundings when vehicle is being lowered. Immediately move out of the way if vehicle is
unstable, tipping or falling. Failure to move may cause to be struck by vehicle; struck by a falling or flying
object. (See Additional Safety Warnings)
19. No alterations shall be made to this product.
20. Only attachments and/or adapters supplied by the manufacturer shall be used.
21. Never work on, around, or under a load that is not secured and stable.
22. Keep operator's and bystander's head, hands, and feet away from lift arms when raising and lowering.
23. Do not use this product for any use other than the manufacturer specified usage.
24. Failure to heed these markings may result in personal injury and/or property damage.
ADDITIONAL SAFETY WARNINGS:
a) Use of this product is limited to lifting, lowering, and storing in the lowered position loads consisting of a
single motor vehicle whose lift points are compatible with the lift platform. Incompatibility is evident when
the loaded vehicle wobbles, appears unstable, and/or does not securely engage the lift platform.
b) Restraining an incompatible load will not make the load secure and may cause unexpected loss of load.
All manuals and user guides at all-guides.com
4