Human Touch SUPER NOVO Manual De Instrucciones página 5

Remove the foot/calf massager
NOTE: The purpose of removing the foot/calf massager is to significantly reduce the weight and improve the maneuverability of
the chair for moving.
1. Lift up the foot/calf massager to expose the connectors behind it (Fig.1).
2. Insert the provided screwdriver into the slot on the top of the connector to release it, then disconnect the connector.
IMPORTANT: Do not attempt to disconnect the connector without first releasing it or you may damage the wiring (Fig.2).
(Fig.1)
3. Pull outward on the air hose to disconnect it (Fig.3).
4. Lower the calf massager.
5. Unzip the upholstery that connects the foot/calf massager to the seat (Fig.4).
6. Locate the clip that secures the foot/calf massager on one side, then rotate it until you see three loops on top (Fig.5).
7. Thread the provided zip tie through the loops, then hang onto both ends of the zip tie to ensure that the clip does not fall into the chair.
8. Rotate the clip onto its side to expose the tab that holds it in place, use your finger to pry open the tab, then pull the clip off the
mounting post (Fig.6).
9. Repeat steps 6 – 8 to remove the clip from the other side of the foot/calf massager.
10. Slide the foot/calf massager to one side until the mounting bracket clears the post, pull the foot/calf massager slightly forward on
that side, then slide the other mounting bracket off the post to remove the foot/calf massager from the chair.
Air hose
Calf clip
(Fig.3)
(Fig.5)
Connector
(Fig.2)
(Fig.4)
(Fig.6)
Unzip
Tab
5