Cleaning The Fl Oor Nozzle; Troubleshooting - Bosch BBS81PET Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 248
15
Fig.
Tapping the dirt out of the plate fi lter
If the plate fi lter is particularly dirty, the dirt can also
be tapped out.
To do this, remove the plate fi lter from the outer fi l-
ter unit and tap it out over a dustbin.
Once you have cleaned the plate fi lter, it is ready for
use immediately.
!
Please note: The fi lter does not need to be rinsed
out.
16
Fig.
Cleaning the fl uff fi lter
Take the fi lter unit out of the dust container.
a) It is usually suffi cient to lightly shake or tap out the fl uff
fi lter when the dust container is emptied in order to
dislodge any particles of dirt.
b) If this is not suffi cient, you can use a dry cloth to remo-
ve dirt particles from the surface.
17
Fig.
Insert the plate fi lter into the outer fi lter unit and
lock it in place by turning it clockwise.
Insert the fi lter unit into the dust container, making
sure it is correctly seated. Insert the dust container
into the appliance, so that it clicks audibly into
13
place.
Fig.
Cleaning the fl oor nozzle
Before carrying out any maintenance, switch off the
vacuum cleaner and disconnect it from the charging
cable.
18
Fig.
a) Turn the rotary brush anti-clockwise
and pull it out to the side of the fl oor nozzle.
b) Use scissors to cut through threads and hairs wound
round the brush and then remove them.
c) Slide the rotary brush in at the side of the fl oor nozzle
and along the guide bar, and turn it clockwise
it in place.
!
Please note: The fl oor nozzle must only be used with
the rotary brush fi tted.

Troubleshooting

Problem
Product doesn´t work
and/or
no signal from
battery status indicator
Product doesn't work
or continuos red battery
status indicator for 10
sec.
62
12
Fig.
to unlock it
to lock
Possible solution
Please ensure that bat-
tery is assembled in cor-
rect way and/or battery
is charged.
Battery/appliance might
be over/under heated.
Please wait until bat-
tery/appliance
reaches
suitable temperatures.
Care
Make sure that the cordeless handheld vacuum clea-
ner is switched off and disconnected from the charging
cable before cleaning it. The vacuum cleaner and plas-
tic accessories can be cleaned with standard plastic
cleaner.
!
Caution: Do not use abrasive, glass-cleaning or
all-purpose cleaning products. Never immerse the
vacuum cleaner in water.
Subject to technical modifi cations.
Battery state-of-charge indicator
Operating status
Normal mode
Turbo mode
Battery capacity redu-
ced by 20%
Battery fl at
Charging
Battery fully charged
Over-/undertemperature
protection
* Depending on model
LED indicator
Green LED lit
Green LED fl ashing
quickly
Red LED fl ashing slowly
LED off
Green LED fl ashing slow-
ly
Green LED remains lit
for a further 2 minutes,
then goes out
Red
LED
remains
continuously for 10 se-
conds, then goes out
lit
Tabla de contenido
loading

Tabla de contenido