Something Not Working; Possible Cause - Zanussi FE 827 GL FE 1027 G Manual De Uso

Something not working?

Problems which you can resolve yourself, before calling the After Sales Service.
During machine operation it is possible that the END light
4 flashes= the door has not been closed
2 flashes= the machine does not empty
1 flash= the machine does not fill.
Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty and/or
does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
• The machine vibrates or is noisy:
All manuals and user guides at all-guides.com
• The door is not firmly closed.
• The machine is not plugged in or there is no power
• The main fuse has blown.
• The programme selector dial is not positioned
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
• The drain hose is squashed or kinked.
• A programme which ends with water in tub
• The option
• The drain pump is clogged.
• Too much detergent or unsuitable detergent
• Check whether there are any leaks from one of the
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
• Too little or too much detergent has been used.
• An unsuitable detergent has been used.
• Stubborn stains have not been treated prior to
• The correct temperature was not selected.
• Excessive laundry load.
• The transit bolts and packing have not been removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
19
starts to flash:

Possible cause

at the socket.
correctly and the START/PAUSE button has not
been depressed.
relevant paragraph in "water drainage" section.
(option ) has been selected.
has been selected.
(creates too much foam) has been used.
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
been replaced after cleaning the pump.
washing.