Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The hood is provided with a special power cable ; if the cable
is damaged, request a new one from Technical Service.
Mounting
Before beginning installation:
•
Check that the product purchased is of a suitable size for
the chosen installation area.
•
Remove the charcoal (*) filter/s if supplied (see also
relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.
•
Check (for transport reasons) that there is no other
supplied material inside the hood (e.g. packets with
screws (*), guarantees (*), etc.), eventually removing
them and keeping them.
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood.
Do not tile, grout or silicone this appliance to the wall.
Surface mounting only.
Operation
This product is designed to work with an Elica remote control,
either supplied with the product or purchased separately as an
optional.
To control the hood via remote control, the affiliation
procedure must be carried out.
CAUTION!
To begin, the hood must be disconnected and then
reconnected to the power supply and the affiliation procedure
must be carried out within the first minute of connection to the
power.
Read the instructions supplied with the remote control, which
provide detailed instructions on affiliation and correct use.
Note: Using the remote control, delayed shut-down can be
programmed based on the aspiration speed (power) enabled
at that moment:
Speed 1 (low aspiration): 20 minutes
Speed 2 (medium aspiration): 15 minutes
Speed 3 (high aspiration): 10 minutes
To select the functions of the hood you simply touch the
controls.
24
Button ON/OFF 'Anti-condensation
Function': is used to prevent
condensation from forming on the
surface of the hood. To be activated
when needed.
'Automatic
anti-condensation
Function': the hood enables the
function every time it is switched on.
Automatic activation ON/OFF: with
the hood off, press and hold the
button (about 3 seconds until you
hear a "beep" sound signal) to enable
or disable the function.
Note:
The
anti-condensation
function, in any case, is only
activated with the motor started.
Attention! Even if this function is
never activated, perform anyway
the maintenance of the drain pan
periodically,
as
indicated
section 'Maintenance - Cleaning –
Maintenance of the drain pan'.
Button ON/OFF light
Press briefly to switch on or off the
lighting of the hob.
Press and hold to switch on or off the
ambient light (only certain models).
Button
to
select
High
Intensive speed (suction power)
Press to activate High speed (Suction
power).
Press again to activate Intensive
speed (Suction power) (the button
flashes for 5 minutes then it returns
to medium speed (suction power).
Button to select medium speed
(suction power)
Button to select low speed (suction
power)
Button OFF motor (stand by)
in
and
Tabla de contenido
