Cognex In-Sight 8000 Serie Manual página 8

Connect the Breakout Cable (Optional)
CAUTION: A ferrite is included with the In-Sight 8405 vision system standard
components. To reduce emissions, the ferrite must be attached to the
Breakout cable.
Note:
I/O wiring or adjustments to I/O devices should be performed when
l
the vision system is not receiving power.
The Ethernet cable should be unplugged or the PoE source powered
l
down before making adjustments to the connections at the far end of
the Breakout cable.
Unused bare wires can be clipped short or tied back using a tie made
l
of non-conductive material.
1. Verify that the vision system's power supply is unplugged and not receiving
power.
2. If installing the In-Sight 8405 vision system, attach the ferrite around the
Breakout cable, adjacent to the strain relief on the cable.
3. Connect the Breakout cable's M8 connector to the vision system's I/O
connector.
4. Connect the trigger and high-speed I/O wires to an appropriate device (for
example, a PLC, trigger sensor or strobe light).
8