Service Information - Black and Decker BDCSMCA Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

• Pull collar back while holding the cutter in

place (Figure D).

• Rotate to desired position and release the

collar (Figure E).

CAUTION

: Do not operate the

screwdriver with the attachment in either of the

two positions marked with

is not secured in these positions and may fall

off during use (Figure F).

use

• Make sure your screwdriver's forward/

reverse switch is in the forward position.

• Lightly place blade (2) against work to be cut

as shown in Figure G.

All manuals and user guides at all-guides.com

. The attachment

• To switch the trigger on the screwdriver.

• Always hold cutter firmly while cutting.

• To switch the tool off, release the trigger.

Approved mAteriAls

This tool is intended for use with paper, fabric,

plastic, cardboard, leather, canvas, wallpaper,

thin rubber, thin carpet, vinyl, and thin wire mesh.

proJeCt tips

• Cut only with sharp blades; they cut cleaner, faster

and put less strain on the motor while cutting.

• When cutting materials with adhesive

backing periodically clean blades; adhesive

residue will build up on blades reducing the

quality of cut and strain the motor.

• When cutting curves, do not tilt the tool; keep

the blades perpendicular to the work piece.

• Advance blades into the material without

forced effort or unnecessary pressure. A

little practice will enable you to determine

what forward pressure gives you the

smoothest cutting.

removing AttAChment (figure h)

• To remove, pull collar back and rotate

attachment until the arrows (6) line up with

the top and bottom of screwdriver.

• Pull attachment off.

MAINTENANCE

CAUTION

: Remove the attachment from

the tool prior to cleaning.

Use only mild soap and damp cloth to clean

the tool. Never let any liquid get inside the tool;

never immerse any part of the tool into a liquid.

IMpORTANT: To assure product SAFETY

and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual)

should be performed by authorized service

centers or other qualified service personnel,

always using identical replacement parts.