Conference Calls - Gigaset L410 Manual De Instrucciones

Conference calls

A call is being held on the handset or on the Gigaset
L410. You would like to participate in the call with
¤
(another) Gigaset L410.
Hold down the Answer/End call key on the Gigaset
L410 (until you hear a short signal tone).
A call is being held on the Gigaset L410. You would
¤
like to participate in the call using the handset.
Hold down the Answer call key on the handset.
This applies to telephones that support the "Listening In" function. If necessary, switch
this function on.
Note
On telephones without the "Listening In" function (e. g. ISDN or IP
telephones), or if the function is switched off:
Handset:
(is in an external
call)
Gigaset L410:
Handset:
All participants hear a signal tone when a participant joins or leaves the
conference call.
Note
Acoustic feedback (whistling noise) may occur when you are phoning in the same
room with a Gigaset L410 and a handset in handsfree mode. In this case, end the
handsfree mode on the handset or increase the distance between the devices.
¤
Call the Gigaset L410 on an internal line (with Gigaset
telephones, press the Int key to do so, where necessary,
select the Gigaset L410 from the list of handsets registered,
press Answer call key).
¤
Accept the call.
¤
Start the conference call as described in the operating
instructions for the handset.
26
External
participant
or two Gigaset L410