Installation Steps - LUND Running Board Bracket Kit 2015-16 Ram 1500 Instrucciones De Instalación

Installation Steps

Identify the (3) mounting locations for each bracket by looking under the driver side of the vehicle at the rocker panel and pinch welds.
Driver side
shown
1
Align the Front Bracket with hole in rocker panel and the (2) holes in the pinch weld. Install (1) bolt with (1) washer in upper
Bolt with washer
in upper bracket
hole, threaded
into rocker panel
Front Bracket
2
Install (2) bolts with (2) washers in the pinch weld from the OUTSIDE, and secure with (2) nuts. NOTE: Do NOT fully tighten at
Front Bracket
3
NOTE: Actual application may vary slightly from illustrations.
NOTE: Check to see if the Middle and Rear locations have threaded or open holes.
Front Bracket
bracket hole in rocker panel. NOTE: Do NOT fully tighten at this time.
Middle Bracket
Fig. 1
Fig. 2
this time.
(2) bolts with (2) washers
and (2) nuts installed in
pinch weld
Fig. 3
Page 2 of 5
Rear Bracket
(2) holes in pinch
weld
nut
pinch weld
bolt
washer