Installation Steps - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Buff the vinyl rubber window channel with a scotch brite pad, and clean with an alcohol pad. Wipe dry with a soft cloth.
Apply one coat of surface prep to rubber trim. NOTE: Prep rubber trim on both sides before installing the visors to prevent
1
Remove tape liner from rear flange of visor. Peel back 2" (5 cm) of tape liner from each end of the lateral flange.
2
Align the visor on the vehicle door. The lateral flange will apply below the metal trim onto the vinyl window channel. The front
3
Gently press the exposed areas of tape against the surface and
verify position.
4
NOTE: Actual application may vary slightly from illustrations.
free end
rear
flange
end flange will attach on top of the mirror base plate.
towelette from drying.
lateral flange
free end
front
flange
With the visor in its final position, remove the remaining tape liner
5
Page 2 of 3
Rubber trim
Metal trim
PRESS
Visor
Buff this area with
scotch brite pad
by pulling on free ends.
Vinyl Window
Channel