Step 5: Mount Your Gate - Munchkin MKSA0658-011 Manual Del Usuario

How To Install
6a. For Drywall Without Stud / Plasterboard:
Drill a 7/32" (5.5mm) hole into the drywall at the
center mark. Insert a drywall anchor.
Peel the back off the sticky pad that is attached to
the wall cup. Then stick the wall cup onto the wall
to fit your pencil marks.
Use a screwdriver or drill to insert the screw through
the center of wall cup into the drywall anchor.
Drywall
Anchor
6b. For Drywall with Stud:
Drill a 5/64" (2mm) pilot hole into the stud
(no anchor needed).
Peel the back off the sticky pad that is attached to
the wall cup. Then stick the wall cup onto the wall
to fit your pencil marks.
Use a screwdriver or drill to insert the screw through
the center of the wall cup into the stud.
10
All manuals and user guides at all-guides.com
6a. Drywall
7/32"
5.5mm
6a. Plasterboard
7/32"
5.5mm
6b. Stud
5/64"
2.0mm

STEP 5: MOUNT YOUR GATE

1. Place the gate where you want to install it, then extend all 4 adjustment rods
until they reach the walls. Ensure that the ends of the adjustment rods are seated
inside the cups.
How To Install
11