Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How To Install
Getting Started
STEP 1: IDENTIFY GATE PLACEMENT
For maximum security, DO NOT use this gate in any location without installing all
4 wall cups, sticky pads and screws provided. In some openings only 2 top wall cups
can be fitted. The gate must be installed between two structurally sound surfaces.
GATE IS SUITABLE FOR:
TOP OF STAIRS
If installing the gate at the top of stairs, it MUST be
placed on the top landing and only swing away from
the stair.
BOTTOM OF STAIRS
If installing the gate at the bottom of stairs, we
recommend placing it on the floor. If the gate must
be placed on the lowest stair, position it toward the
front of the step.
HALLWAYS AND DOORWAYS
Be sure that the gate is resting on the floor.
The gate should NOT be raised above the floor.
6
All manuals and user guides at all-guides.com
STEP 2: VERIFY PROPER WIDTH
Measure the width of the opening where the gate will be installed. Be sure to measure
at the narrowest point between the walls. For example, include any baseboards in your
measurement. Then, see below for the proper gate configuration for your opening.
TOOLS NEEDED:
• Tape measure
29.5" - 32.5" (75CM - 82.5CM)
Insert all 4 adjustment rods with
threaded nuts.
(Proceed to page 9.)
OPENING OPTIONS BELOW:
A. 33" - 35" (83.8CM - 88.9CM)
Insert one 2.75" (7cm)
extension to the hinge side of
the gate as shown in the image
to the right.
(Proceed to page 8.)
B. 35.4" - 37.8" (89.9CM - 96CM)
Insert one 5.5" (14cm) extension
to the hinge side of the gate as
shown in the image to the right.
(Proceed to page 8.)
C. 37.8" - 40.6" (96CM - 103.1CM)
Insert one 5.5" (14cm) extension
to the hinge side of the gate, &
one 2.75" (7cm) extension to the
handle side of the gate as shown
in the image to the right.
(Proceed to page 8.)
Please see page 15 for additional extension configurations.
How To Install
7
Tabla de contenido
