Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How To Install
STEP 3: ADD EXTENSIONS
TOOLS NEEDED:
Flathead screwdriver
1. Remove the upper and lower plugs from the
side of the gate. You may need to use a
flathead screwdriver to remove the plugs.
2. Install the fully assembled extension by inserting the
upper and lower extension adapters into the gate, in
the holes where you removed the plugs.
3. Reinsert the plugs that you removed earlier into the
extension adapters, along with the adjustment rods.
Please be sure the slot on the plug is facing down
towards the floor.
NOTE: If installing a 5.5" (14cm) or 11" (28cm)
extension, you will not use an upper plug.
8
All manuals and user guides at all-guides.com
1
Bottom plug
2
3
Slot
STEP 4: INSTALL WALL CUPS
TOOLS NEEDED:
• Drill
• Phillips screwdriver
• Pencil
1. Ensure the wall cups are on the end of 4 adjustment rods.
2. Temporarily place the gate where you want to install
it, flush against the floor. Pull the adjustment rods out
until they reach the walls and trace the position of
each wall cup with a pencil.
3. Retract the adjustment rods and set the gate
aside for now.
4. Hold the wall cup in position and mark the center
with a pencil. Then put the cup aside.
5. Determine whether there is a stud behind the drywall
where you will install each wall cup. Proceed to either
6a or 6b on the next page.
PLEASE NOTE: The gate should be resting on the
floor. DO NOT allow a gap of more than 0.196" (5mm)
between the gate and the floor.
How To Install
2
4
Gate
Floor
9
Tabla de contenido
