Techness RUN1000 Manual Del Usuario página 20

Incline motor learn by itself
E04
Over current protection:
treadmill is running, control
board check the current is
E05
over standard current +6A
for 3 seconds
Over explosion protection:
voltage is not correct or
E06
motor not work well, cause
motor wire bad.
Proper maintenance is very important to ensure a faultless and operational
condition of the treadmill. Improper maintenance can cause damage to the treadmill
or shorten the life of the product.
All parts of the treadmill must be checked and tightened regularly. Worn out parts
must be replaced immediately.
1. LUBRICATION:
The treadmill is factory-lubricated. However, it is recommended to check the
lubrication of the treadmill regularly, to ensure an optimal operation of the
treadmill. It is usually not necessary to lubricate the treadmill in the first year or the
first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface
of the belt, as far as possible. If traces of silicon spray are found, lubrication is not
necessary.
In case of a dry surface refer to the following instructions.
Only use oil free silicon spray.
Check the incline motor wire, and wire
connections. Check the AC wire on incline
motor and the connection to control board.
Change the wire or incline motor. Then press
the key to let the incline motor learn by itself.
Treadmill cannot start, warning sound 9times.
Console show the E05. If treadmill can restart in
10 seconds, it will be ok.
Solution: current is over the standard current,
so system take protection. Or some part cannot
work; causing the motor cannot run normally.
Recheck the treadmill, and restart the treadmill.
Check if the bad smell, change motor, or control
board has. Recheck the current is right or not.
Treadmill cannot start, warning sound 9times.
Console show the E06. If treadmill can restart, it
will be ok.
Solution: check the voltage is lower than 10%
standard voltage, using the correct voltage to
check again. Check control board smelling, if
burnt smell, change control board. Check the
motor wire connection, reconnect.