Tabla de contenido
If the pins fall out:
• Completely remove the tube clamp cover.
• Position the pins on the left and right side of the thread. Be sure to have the correct mounting
orientation of the pin with the bore (item 3).
• Put the tube clamp cover over them.
3)
Put the new O-ring into the notch provided.
4)
Lower the tube clamp cover and tighten the screw.
1
3
11 Technical Data
Proximal connection
Distal connection
Knee flexion angle
Weight
System height
Proximal system height from alignment reference point
Distal system height up to alignment reference point
Material
Admissible temperature range
Max. user weight
Mobility Grade
12 Liability
The manufacturer recommends using the device only under the specified conditions and for the
intended purposes. The device must be maintained according to the Instructions for Use. The
device must only be operated with tested modular components in accordance with the Otto Bock
Mobility System. The manufacturer is not liable for damage caused by component combinations
that were not authorized by the manufacturer.
13 CE Conformity
This product meets the requirements of the 93/42/EWG guidelines for medical products. This
product has been classified as a class I product according to the classification criteria outlined in
appendix IX of the guidelines. The declaration of conformity was therefore created by Otto Bock
with sole responsibility according to appendix VII of the guidelines.
18
All manuals and user guides at all-guides.com
5
4
2
Pyramid adapter (movable)
Tube clamp ⌀ 30 mm
150 °
385 g
23 mm
12 mm
11 mm
Plastic
-10 °C / +40 °C
100 kg / 220 lbs
1
Tabla de contenido
