Oasis 504815C Guia Del Usuario página 7

CONVERTING TO DIRECT WATER LINE (bottle-less water option)
Your cooler comes ready to use a 3-gallon (11.4 L) to 5-gallon (18.9 L) water bottle, or it can be used with
a direct water line connection and filtration system. If the inlet water pressure is above 100 psi, a pressure
regulator must be installed in front of the unit's water inlet.
1. Remove the bottle siphon from the door by pulling the handle away from the door.
(See arrow in Fig. A)
2. Disconnect the (1) Bottle Siphon tube (1/4") and (2) Return tube (3/8") from the Bottle Siphon assembly
quick-connect fittings. (See Fig. A)
3. Join both tubes together with the supplied quick-connect fitting. (See Fig. B)
4. Store the siphon in a safe place for future use. The siphon assembly fits in the open space next
to the condenser.
5. At the rear of the unit, locate the water connection fitting with a coil of tubing next to the condenser.
When using a Filter system, disconnect the Elbow (In-line) fitting at the mid length of the tube, and store
for future use with the Bottled water feature. (Fig. C)
Fig. A
1
2
WATER TUBE CONNECTION/DISCONNECTION PROCEDURES
Collet
Body
To connect, push tube through collet
ring into body.
Note: Do not use water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.
Fig. B
Bottle Siphon tube (1/4")
Return tube (3/8")
Tube must sit fully past o-ring.
Fig. C
to filter
outlet
remove fitting
for filter use
To disconnect, hold collet ring against
body and pull tube out.
Rear of cooler
water connection
to filter inlet
7