Machine Use - Delta 31-695 Manual De Instrucciones

MACHINE USE

Fig. 44
SURFACING OR EDGE SANDING WITH THE SANDING BELT
When surfacing (Fig. 44) or edge sanding (Fig. 45), place the sanding arm in the horizontal position and use the backstop
(A) Fig. 44 and Fig. 45 to keep the workpiece in place. Hold the workpiece firmly and keep your fingers away from the
sanding belt. Place the end of the workpiece against the backstop and move the workpiece evenly across the sanding
belt. Apply only enough pressure to allow the sanding belt to remove material. Use extra caution when sanding very thin
pieces.
Position the edge of the backstop a maximum of 1/16" away from the sanding belt to avoid trapping
the workpiece or your fingers between the backstop and the sanding belt.
SANDING INSIDE CURVES
You can sand inside curves on the top sanding drum
(Fig. 46).
Replace the sanding drum guard after
the sanding operation is completed.
SANDING OUTSIDE CURVES
Sand outside curves on the sanding disc as illustrated in
Fig. 47.
Always sand on the left (downward) side
of the sanding disc. Sanding on the right (upward)
side of the sanding disc could cause the workpiece
to fly up, which could be hazardous.
The edge of the table must be
positioned a maximum of 1/16" away from the
sanding disc to avoid trapping the workpiece or
fingers between the table and sanding disc.
All manuals and user guides at all-guides.com
A
18 - English
Fig. 45
A
Fig. 46
Fig. 47