Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ATTACHING THE SANDER TABLE
1. Insert the support rod (A) Fig. 14 into the hole in
the side of the sander until the rod (A) extends
approximately 5-1/2". Align the flat on the rod (A) with
the hole for the set screw (B). Insert the M10 x 12mm
set screw and tighten screw with hex wrench (C).
2. Slide the table assembly (D) Fig. 15 on the rod (A).
Make sure the flat on the rod (A) aligns with the holes
for the set screws at (E). Insert two M10 x 12mm
set screws and tighten the screws to hold table
assembly (D) in position.
To avoid trapping the work or fingers
between the sanding disc and the table, the table
edge (F) Fig. 15 should be positioned a maximum of
1/16" away from the sanding disc (G). Loosen the
screws (E) and adjust the table accordingly.
NOTE: The remaining M10 x 12mm set screw will be
used when the sander table is moved and used with the
sanding belt. See "USING THE TABLE ASSEMBLY WITH
THE SANDING BELT."
ATTACHING THE BACKSTOP
1. Align two holes in backstop (S) with holes (W) Fig. 15A.
Place an M6 lock washer, then an M6 flat washer, onto
the M6 x 12mm Socket Head Cap Screws and use
these to attach backstop.
OPERATIONAL CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING SANDER
Make sure that the switch is in the
"OFF" position before plugging cord into outlet. Do
not touch the plug's metal prongs when unplugging or
plugging in the cord.
The on/off switch (A) Fig. 16 is located on the front of the
sander base. To turn the machine "ON", move the switch
up to the "ON" position. To turn the machine "OFF",
move the switch (A) down to the "OFF" position.
All manuals and user guides at all-guides.com
OPERATION
11 - English
B
C
G
E
A
S
Fig. 15A
A
5-1/2"
A
Fig. 14
F
D
Fig. 15
W
Fig. 16
Tabla de contenido
