HURAKAN HKN-VAC260 Manual Del Usuario página 23

The line of package
sealing is uneven.
The sealing seam
surface is not flat.
Fragile sealing.
The package
explodes when the
air is completely
deflated.
Notes: 1. The instructions are for reference only. In case of non-compliance,
2. There are no additional instructions for the different individual
3. There are no additional guidelines for improved design.
The heating sealing fuse is blown-out.
The electrothermal ribbon is torn.
Short circuit of electrothermal tape.
The sealing contactor is broken
The solenoid valve of the small gas element
does not work.
The sealing tape is jammed and not moving.
The electrothermal tape is loosely fixed.
The heating sealing pressure is not enough.
Not enough time to cool down.
The sealing place is dirty.
Not enough time for sealing.
The heating sealing voltage is wrong.
Changing the voltage.
The heating sealing pressure is not enough:
1. Too long ventilation increases the
pressure in the vacuum chamber too
much.
2. The sealing tape is jammed and not
moving freely.
3. The valve of the small gas element is
not switched on freely.
4. A small gas element or its hoses are
leaking.
Teflon coating is dirty or damaged.
The low quality of the packages.
Incorrect location of the sealed tape and too
short distance lead to the fact that the air
leaves unevenly and creates pressure inside
the package.
please, contact our technical department.
mechanisms that make up the above models.
Replace
Replace
See table 7-2
Tighten the tape
Increase the time
Adjust
Adjust the motor
Adjust the motor
Adjust
See table 7-2
Replace
Adjust the position by
repairing.
EN
23