Allen-Bradley Kinetix 2000 Instrucciones De Instalación página 8

8
Kinetix 2000 Shunt Module
Shunt Module Connector Data
The internal shunt resistor (15 Ohm, 50 W) is the default setting for the shunt module.
Jumpers are factory installed from TS-1 to TS-2 and from RC-1 to RC-2 to make this default
selection.
Connectors on the shunt module are supplied with removable wiring plugs.
Shunt Module Connectors and Pinouts
Designator Description
TS External passive shunt module
thermal switch connections
RC External resistor connection
Internal shunt connection
External collector connection
(1)
Jumper is factory installed between these TS pins to select the internal thermal switch.
(2)
Jumper is factory installed between these RC pins to select the internal shunt resistor.
Shunt Module Connectors and Indicators
External Thermostat
(TS) Connector
External Shunt Resistor
(RC) Connector
Publication 2093-IN002A-MU-P - December 2006
Connector
Two position
connector housing
Three-position
connector housing
Shunt Module, Front View
(2093-ASP06)
Power Fault LED
Over-temp Fault LED
Bus Status LED
TS1
TS2
DC+
INT
COL
Pin Signal
(1)
1 TS1
(1)
2 TS2
1 DC+
(2)
2 INT
(2)
3 COL