Makita DFL201F Manual De Instrucciones página 4

ENGLISH
(Original instructions)
1 Red part
2 Button
3 Battery cartridge
4 Indicator lamps
5 Check button
6 Switch trigger
7 Reversing switch lever
SPECIFICATIONS
Model
Fastening torque
Square drive
No load speed (min
Overall length
(Depending on the battery)
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
8 Lamp
9 LED indicator
10 Screws
11 Angle head
12 Adjust ring
13 Ring
14 Scale
Hard joint 8 – 20 N•m
Soft joint 8 – 20 N•m
–1
)
417 – 429 mm
1.5 – 2.1 kg
BL1415N / BL1415NA / BL1430 / BL1430B / BL1440 / BL1450 /
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
ENE033-1
GEA010-2
DFL201F DFL301F
16 – 30 N•m
16 – 30 N•m
9.5 mm
360
465 – 477 mm
1.7 – 2.1 kg
D.C. 14.4 V
BL1460A / BL1460B
CORDLESS SCREWDRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where
the fastener
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch
immediately after operation; they may be
extremely hot and could burn your skin.
6. Always secure workpiece in a vise or similar
hold-down device.
SAVE THESE INSTRUCTIONS.
15 Adjust grip
16 Hole for adjust grip
17 Yellow line
18 Compression spring
19 Socket
20 Hole
21 Pin
DFL402F
25 – 40 N•m
25 – 40 N•m
9.5 mm 9.5 mm
260
465 – 477 mm
1.7 – 2.1 kg
may contact hidden
the bit or the
200
GEB139-1
wiring.
workpiece