Mini Transporter Operation; Adding Fuel; Starting Engine; Operating - Honda HP311 Manual De Instrucciones

MINI TRANSPORTER
OPERATION

Adding fuel

Fill the fuel tank as instructed in the separate Engine Manual packed
with the machine.
Fill tank to no more than 12.5mm (1/2") below the
bottom of the filler neck to provide space for expansion.

Starting engine

A more detailed description of the engine operation and all related
precautions and procedures can be found in the Engine Manual packed
separately with the mini transporter.
Follow the procedure below for cold starts:
1. Put the gear shift lever at the idle speed position.
2. Turn choke lever on the engine to full choke position.
3. Turn the engine switch on.
4. Pull the starting rope slowly several times to allow the gasoline to
flow into the engine's carburetor. Then hold the start handle firmly
and pull rope out a short distance until you feel some resistance.
Then pull the rope smoothly and briskly, and allow rope to return
gently. Do not let the rope snap back. If necessary, pull the rope
several times until the engine starts.
5. Allow the engine to run for several seconds to warm up. Then,
gradually move chock lever to "OPEN" position.
Please not to operate the direction change lever before
the engine warming up after several seconds.
Restarting an engine that is already warm from previous running does
not normally require use of the choke.
1. Set the throttle lever on the handlebar at half- way position.
2. Hold the start handle firmly and pull rope out a short distance until
you feel some resistance. Then pull the rope smoothly and briskly,
and allow rope to return gently. Do not let the rope snap back.

Operating

After engine warms up, slowly squeeze the clutch control lever,then
engage the required gear, If the gear does not engage straight away,
slowly release the clutch lever and try again. In this way the mini
transporter will start moving.
Pull throttle lever to accelerate engine speed.
The mini transporter has the steering levers on the handlebars and this
makes steering very easy. To turn right or left, simply operate the
corresponding right or left steering lever.
The sensitivity of the steering increases in proportion to the speed of the
machine and that with the empty machine, a light pressure on the lever
is all that is needed to turn. While when the machine is loaded, more
pressure is required.
The mini transporter has a maximum capacity of 300kg. However, it is
advisable to assess the load and adjust it according to the ground on
which the machine will be used.
It is therefore advisable to cover such stretches using low gear and
taking extra care. In such situations, the machine should be kept in low
gear for the whole stretch.
Avoid sharp turns and frequent changes of direction while driving on the
road, in particularly on rough, hard terrains full of sharp, uneven points
with a high degree of friction.
Even though the unit has rubber tracks, remember to be careful when
working in adverse weather conditions (ice, heavy rain and snow) or on
types of ground that could make the mini transporter unstable.
Please note that as this is a tracked vehicle, it is subject to a considerable
pitching movement when passing over bumps, holes and steps.
When the clutch control lever is released, the machine will stop and
brake automatically, throttle lever will be disabled.
If the machine is stopped on a steep slope, a wedge should be placed
against one of the tracks.

Idle speed

Set throttle control lever to its "SLOW" position to reduce stress on the
engine when working is not being performed. Lowering the engine speed
to idle the engine will help extend the life of the engine, as well as
conserve fuel and reduce the noise level of the machine.

Stopping engine

To stop the engine in an emergency, release the clutch control lever,then
turn the engine switch to the OFF position. Under normal conditions, use
the following procedure:
1. Move the throttle lever to the SLOW position.
2. Let engine idle for one or two minutes.
3. Turn the engine switch to the OFF position.
4. Turn the fuel valve lever to the OFF position.
Do not move choke control to CHOKE to stop engine.
Backfire or engine damage may occur.
32