Idiomas disponibles
Idiomas disponibles
6. Thread the Nut Plate approximately 2mm, or 2-4 threads,
onto the bolt.
FIGURE 6
7. Verify the assembly looks like Figure 7 up to this point.
FIGURE 7
8. Insert the 2" tube to the bracket onto the mounting bracket
as shown in Figure 8. Then attach the tube using a flat
washer, lock washer, and 3/8" x 1-1/4" Hex Bolt.
NOTE: The ends of the tube are different, one of them has
a key that inserts into a corresponding square slot on the
bracket to ensure that the tube will not spin. See Figure 9.
The other end without the key, fits flush to the bracket and
attaches with the 3/8" bolt. The tube can be positioned
with the key to front or rear orientation.
FIGURE 8
BOLT
3/8" X 1 1/4"
Tubular Side Rails
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
9. Repeat steps 1-8 for the Front Passenger side.
FIGURE 9
10. Position the tube assembly over the stake pockets. See
Figure 10.
FIGURE 10
11. Insert the nut plate into the Rear Driver stake pocket. The
nut plate needs to be inserted at an angle in the pocket as
shown on Figure 11. Repeat procedure for the Front Driver
assembly.
Note: Rear must be installed prior to front due to limited
movement in the stake pocket.
FIGURE 11
PART NO.
REV 04AP07
INSTALLATION INSTRUCTIONS
DR
TITLE
Tubular Side Rails
PART NO.
19165847
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19165847
SHEET
2
SHEET
2
9
OF
9
OF
