Clearing The Memory; Battery Replacement - STACK-ON PDS-1800-B Manual De Instrucciones

LOCKING THE SAFE
To lock the safe, close the door and turn the
knob to the left to the 12:00 position.
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds after the
fingerprint is entered, wait a minimum of 6
seconds from the time you have successfully
scanned your finger to lock the safe. Also,
when locking the safe, always make sure the
knob is turned completely to the left to the
12:00 position. If the knob is not turned to the
12:00 position during the locking process, the
locking mechanism will not lock.

BATTERY REPLACEMENT

NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
This safe uses 4 - AA batteries. Under normal
use, batteries will last about 1 year.
NOTE: If the batteries are low, the yellow light
will flash when you start to enter your code.
To replace the batteries, open the battery
compartment on the back of the door by
pushing the tab in the direction of the arrow and
install all new batteries.
TAB

CLEARING THE MEMORY

To clear the memory of all recorded
fingerprints, locate the reset button on the
inside of the safe and press this button for
about 5 seconds until the green light flashes
10X. All recorded scans will be erased.
NOTE: For security you must record a
fingerprint. Failure to do so will compromise
the safety and security of the safe.
INTERNAL LED LIGHT
This safe includes an internal LED light that will
activate when a
will remain on for 30 seconds.
TURNING THE SOUND OFF/ON
Your safe comes with the beep sound
turned on.
To turn the sound off, press the scanner with a
recorded fingerprint for 10 seconds until the
green light flashes 2X.
To turn the sound on, press the scanner with a
recorded fingerprint until you hear two beeps
and the green light flashes 2X.
BATTERY
COMPARTMENT
recorded finger is scanned and
3
12
40792-1805