STACK-ON PDS-1800-B Manual De Instrucciones página 2

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. Any fingerprint will open
the safe until a fingerprint is recorded. For
security you must record a fingerprint. Failure to
do so will compromise the safety and security of
the safe. You can record up to 20 different
fingerprints for opening the safe. For best
results, each individual should use their thumb
or index finger only.
To record a fingerprint, first press the Reset
Button on the inside of the safe. The scanner will
light up with two beeps (if the sound is turned
on), you will then record the same
finger 3X as follows:
1. Place your finger on the scanner until there
is one beep (if the sound is turned on) and
the green light flashes 1X. Lift your finger off
the scanner.
2. Place the same finger on the scanner for a
second time, holding the finger in the same
position until there is one beep (if the sound is
turned on) and the green light flashes 1X.
Lift your finger off the scanner.
3. Place the same finger on the scanner for a
third time, holding the finger in the same
position until there is two beeps (if the sound is
turned on) and the green light flashes 2X.
Lift your finger off the scanner. Your fingerprint
is now recorded.
SCAN THE SAME FINGER 3X
DO NOT SHUT THE DOOR UNTIL YOU
HAVE SCANNED A FINGERPRINT
If the red light flashes 3X with three beeps
(if the sound is turned on) your fingerprint did
not get recorded and you will have to start over.
If you enter more than 20 fingerprints, the red
light will flash 5X and there will be beep 5X
(if the sound is turned on).
OPENING THE SAFE USING YOUR
FINGERPRINT
To open the safe, press the scanner with a
recorded finger. The scanner will light up and
beep 1X (if the sound is turned on) and the
scan will begin.
If the green light fashes 2X with 2 beeps (if the
sound is turned on), the scan has been accepted
and the door will open.
If the red light flashes 1X, the scanner did not
read your fingerprint and you must try again.
If the red light flashes 3X, the scanner read your
fingerprint and did not accept it.
If an incorrect fingerprint is scanned 3 times the
light
will flash red 5X
is turned on) then alarm will sound for
10 seconds resulting in the safe being
automatically locked out for 1 Minute before
scan can be tried again.
The safe will beep 1X (if the sound is turned on)
and the green light will flash 1X when the
lockout period is over.
If an incorrect fingerprint is scanned
1 additional time the light
beep 5X (if the sound is turned on) then alarm
will sound for 30 seconds resulting in the safe
being automatically locked out for 5 minutes
before the scan can be tried again.
The safe will beep 1X (if the sound is turned on)
and the green light will flash 1X when the
lockout period is over.
To close the safe, push the door closed
until locked.
NOTE: In certain dry climate conditions, your
fingerprint may not scan. If your fingerprint did
not scan, we recommend moisturizing with
minimal lotion and trying again.
and beep 5X (if the sound
will flash red 5X
40792-1805
and
2
12
Tabla de contenido
loading

Tabla de contenido