Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLING THE BATTERIES
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
Pull the foam upward and away from the battery
compartment. Remove the battery compartment by
pushing the tab and pulling the compartment out as
shown. Install (4) AAA alkaline batteries as shown.
Reinstall the compartment by hooking the back end
in place and snapping shut. CAUTION: Be careful
not to pinch any wires while reinstalling the battery
compartment.
NOTE: If the batteries are low the red light will go
on while the case is opening. Replace with 4 new
AAA alkaline batteries as shown.
OPEN
CLOSE
When you first install the batteries, you can open the
case by pressing the START button (2). For security
you must record your fingerprint after you install the
batteries so the safe will read only the recorded
fingerprints.
TIPS FOR RECORDING FINGERPRINTS
In order to improve the rate of fingerprint
identification please follow these suggestions:
•
Scan your finger by
sliding it over the scanner
in a straight and even
manner from back to front
taking 1 to 2 seconds to
make the scan.
•
Make sure your entire fingerprint crosses the
scanner.
•
Use a similar scanning motion when opening the
safe.
•
Record several of your fingerprints in case you
sustain a cut or an injury to a finger you have scanned.
•
If your hands have oil, lotion or are dirty the
fingerprints may not scan correctly.
Correct
Incorrect
2
18
40291-1307
Tabla de contenido
