Fujitsu KVM Serie Manual Del Usuario página 13

When connecting a Sun IQ module, you must use a multi-sync monitor in the local port
to accommodate Sun computers that support VGA or composite sync.
4. Locate the power cord that came with the switch and plug the appropriate
end into the power socket on the rear of the switch. Plug the other end into
an appropriate AC wall outlet.
To avoid potential video and/or keyboard problems: If the building has 3-phase
AC power, ensure that the computer and monitor are on the same phase. For best
results, they should be on the same circuit.
WARNING: To reduce the risk of electric shock or damage to your
equipment:
- Do not disable the power cord grounding plug. The grounding plug is an important
safety feature.
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all
times.
- Disconnect the power from the switch by unplugging the power cord from either the
electrical outlet or
the appliance.
- The AC inlet is the main power disconnect.
5. Turn on the switch and monitor, then turn on each target device. After about
one minute, the switch completes initialization and displays the graphical
user interface Free tag on the local port monitor.
6. You can configure the network settings through the OSD or the OBWI.
To configure network settings via the OSD:
1. Press Print Screen to activate the Main dialog box.
2. Click Setup - Network and enter the appropriate Network Speed,
Transmission Mode and Network Configuration settings for your network.
To configure network settings via the OBWI:
1. Point your web browser to the default IP address https://192.168.1.1 to
access the switch.
2. Log in to the OBWI and click the Configure tab.
IQ modules
Typically, IQ modules feature two green LEDs: a POWER LED and a STATUS
LED.
590-1035-640A
2.4 Connecting the Switch Hardware
7