Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Operation of the Power Pak
•
Before operating the appliance, ensure all seals are in good condition. If you
are unsure, replace the seals.
•
Ensure that the hose is connected securely to the valve outlet of the Power Pak
using the supplied spanner to tighten.
•
Connect the other end of the hose securely to the appliance you wish to
operate, using the supplied spanner to tighten.
•
First ensure the control knob on the appliance you are going to operateis in the
"off" position.
•
Insert the two gas cartridges onto the unit by screwing them in place (Fig. 4).
•
Turn the control knob on the Power Pak anti-clockwise to increase the gas fl ow
(Fig. 2).
•
Then turn on the appliance you wish to operate, and light the appliance.
•
Adjust the control knob, to reach the desired level gas fl ow to the appliance.
•
Heat control to be done using the appliance control knob.
4. To disassemble the unit
•
Close the control knob.
•
Remove the cartridge by unscrewing it.
•
Disconnect the hose from the appliance and pack the unit away for storage.
•
Cartridges should always be stored in a cool, dry, well-ventilated area.
5. Checking for leaks (Gas cartridge)
•
To check the gas cartridge for leaks, apply soapy water to the connection area of the gas cartridge and see if any bubbles are visible.
Any leakage will be seen as bubbles coming from the leakage point. If you cannot remedy any leakage, return the cartridge to your
stockist.
503-0386 LEV12 - (346) Power Pak - User Manual 28-30 & 50mBar (EU).indd 2
2 2
Fig. 4
13/05/2016 09:35:39
Tabla de contenido
