Assembly; Install The Wheel Kit; Install The Support Leg; Battery Cable Connection - Firman H08053 El Manual Del Propietario

ASSEMBLY

The generator requires some assembly prior to
usage. If problems arise when assembling the
generator, call 1-844-347-6261.
Kit
CAUTION
The wheel kit is not intended for over-the-road use.
1. Before adding wheels, tip the generator on
side.
2. Slide the axle pin A through the wheel B.
3. Slide the axle pin A through the mount point
on the frame and flat washer D.

Battery Cable Connection

NOTE:
The generator comes equiped with the positive(red) and negative(black) cables already attached to
battery terminals.
1. Cut wire tie that is binding the black battery cables A and B.
2. Insert the male connector of cable A into female connector of cable B.
English
4. Secure the wheel and axle pin with the cotter
5. Repeat steps 2-4 to attach another wheel.

Install the Support Leg

Install the Wheel
1. Attach the rubber support (H) to the support
2. Attach the support leg (G) to the generator
3. Tip the generator slowly so that it rests on the
4. Tighten bolt E and nut F with provide wrenches.
its
Page 08
pin C.
leg (G) with flange bolt (I) (M6X25) and flange
lock nut(J) (M6).
frame with flange bolt (E) (M8X16) and flange
lock nut(F) (M8).
wheels and support leg.
Customer Service: 1-844-FIRMAN1