Assembly; Install The Wheel Kit; Install The Support Leg; Battery Cable Connection - Firman H07552 El Manual Del Propietario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY

The generator requires some assembly prior to
usage. If problems arise when assembling the
generator, call 1-844-347-6261.
Kit
CAUTION
The wheel kit is not intended for over-the-road use.
1. Before adding wheels, tip the generator on
side.
2. Slide the axle pin A through the wheel B.
3. Slide the axle pin A through the mount point
on the frame and flat washer D.

Battery Cable Connection

NOTE:
The generator comes equiped with the positive(red) and negative(black) cables already attached to
battery terminals.
1. Cut wire tie that is binding the black battery cables A and B.
2. Insert the male connector of cable A into female connector of cable B.
English
Install the Wheel
its
Page 08
4. Secure the wheel and axle pin with the cotter
pin C.
5. Repeat steps 2-4 to attach another wheel.

Install the Support Leg

1. Attach the rubber support (H) to the support
leg (G) with flange bolt (I) (M6X25) and flange
lock nut(J) (M6).
2. Attach the support leg (G) to the generator
frame with flange bolt (E) (M8X16) and flange
lock nut(F) (M8).
3. Tip the generator slowly so that it rests on the
wheels and support leg.
4. Tighten bolt E and nut F with provide wrenches.
Customer Service: 1-844-FIRMAN1
Tabla de contenido

Solución de problemas

loading

Tabla de contenido