Before installing and using your air conditioner, please read this owner's manual carefully. Store this manual in a safe place for future
reference. Your safety and the safety of others is very important to us. Please pay attention to all safety messages outlined in this
WARNING:
To reduce the risk of fire, electrical shock or injury when using your air conditioner, follow the following basic precautions:
The electrical ratings for your air conditioner are listed on the model and serial number label located on the front right hand side of the
Be sure to retain your original sales receipt. A valid proof of purchase is required for all warranty claims.
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries
Model #___________________________________
You can locate your 20 digit serial number underneath the bar code (On the right hand side of the AC).
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong.
Do not use an adapter
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock
For your personal safety, this air conditioner must be grounded. This air conditioner is equipped with a 3 prong power supply cord
with a grounded plug. To minimize the possibility of electrical shock, the cord must be plugged into a 3 prong outlet and grounded in
accordance with all local codes and ordinances. If a 3 prong outlet is not available, it is the customer's responsibility to have a properly
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
WE ARE
READY TO
HELP
IMPORTANT SAFETY INSTRUCTIONS
owner's manual.
ELECTRICAL REQUIREMENTS
unit (when facing the front).
REGISTER YOUR APPLIANCE
You can register your appliance online by going to register.tcl.com
BATTERY WARNING STATEMENT
Document your model and serial numbers here:
Specific electrical requirements are shown in the diagram below. Follow the
requirements below for the type of plug on the power supply cord.
Wiring Requirements
• 115 Volt (103 min – 127 max)
• (5K-8K) (0-8 amps)
• (10K-12K) (0-12 amps)
• (5-8K) (10 amp time-delay fuse or circuit breaker)
• (10K-12K) (15 amp time-delay fuse or circuit breaker)
• Use on single outlet circuit only
RECOMMENDED GROUND METHOD
grounded 3 prong outlet installed by a qualified electrician.
FCC CAUTION
the equipment.
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Consult the dealer or an experienced radio/TV technician for help.
The distance between user and device should be no less than 20cm.
DO NOT RETURN TO STORE
contact us first
with any questions
TAKE CARE WHEN REMOVING
THE AIR CONDITIONING UNIT
Serial #___________________________________
TCL SUPPORT:
www.tclusa.com/support
1-800-825-6747
Power Supply Cord