Warning Symbols; Electrical Safety - Black and Decker KX3300 Manual De Instrucciones

The unit must be kept level at
all times.
WARNING: Danger of
Scalding

Warning symbols

The following symbols are used in this
manual:
Read all of this manual careful-
ly before using your appliance.
Always wear protective gloves.
Always wear eye protection.
Denotes risk of electric shock.
Surfaces may become hot
during use and during the cool
down period.

Electrical safety

This product must be earthed.
Always check that the power
supply corresponds to the voltage on the
rating plate.
Power plugs must match the outlet.
Never modify the plug in any way. Un-
modified plugs and matching outlets will
reduce the risk of electric shock.
Extension cables & class 1
product
A 3 core cable must be used as your
u
appliance is earthed and of class 1
construction.
(Original instructions)
Features
1. Boiler carrying handle
2. Pressure relief valve
3. Boiler reservoir
4. Water level indication
5. Hose
6. Steam plate
7. Filler cap
Assembly
Fitting the hose (fig. A and B)
Screw one end of the hose (5) to the hose connector on
u
the boiler tank. Check that the hose has been connected
properly.
Connect the other end of the hose (5) to the steam plate.
u
Check that the hose has been connected properly.
Use
Surfaces may become hot in use. The filler cap
may be hot during use and during the cool down
period.
Initial filling of the boiler reservoir (fig. C)
Warning! Make sure that the appliance is unplugged.
Unscrew and remove the filler cap (7).
u
Note: When filling the boiler, use clean tap water only.
Fill the boiler reservoir (3) with water. Do not overfill the
u
reservoir past the MAX indicator (maximum 4 litres).
Replace the boiler filler cap (7), do not overtighten.
u
Plug the mains plug into the power supply.
u
Reaching temperature (fig. D)
Depending upon the temperature of the water used to fill
u
the reservoir (3), the appliance will take between 6 and 11
minutes to start producing steam.
Refilling the boiler reservoir
Disconnect the appliance from the mains supply.
u
Wait at least 2 minutes for the water to cool and the pres-
u
sure to decrease before removing the boiler filler cap (7).
Warning! The filler cap may be hot during use and during the
cool down period.
Unscrew and remove the filler cap (7).
u
Fill the boiler reservoir (3) with clean tap water. Do not
u
overfill the reservoir past the MAX indicator (maximum 4
litres).
Replace the boiler filler cap (7), do not overtighten.
u
Plug the mains plug into the power supply.
u
Using the wallpaper stripper (fig. E)
Check the state of your plaster before you start work
u
ENGLISH
7