Ocultar thumbs Ver también para PB-650:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Model:
PB-650
S/N:
ALL
Kit Contents:
Upper and Lower Leaf Grids, 7 Brass Collars, 4 Socket head
Screws, 4 Flange Nuts
Tools Required: 4mm Hex Wrench, 8mm Socket Driver, 20 in. Piece of Starter
Rope
NOTE
All locations are described from the operator point of reference.
1. Unhook throttle arm tension spring located in the lower right frame hinge
below the blower pipe elbow. Tie a 20 in. length of rope on the hook end of
the spring and lift it off the hinge tube wall allowing it to retract into the
hinge tube. Tie rope ends around the elbow to aid in reassembly.
2. Detach upper vibration isolator from backpack frame by removing 8mm nut
and washer (A).
3. Remove two 4mm socket head screws, and washers (B) from lower right
frame hinge fixture, and two socket head tapping screws (C) from lower left
hinge fixture. Retain all screws, and washers for later reassembly.
4. Pull throttle arm assembly away from frame hinge, and tilt backpack frame
away from blower housing to access fan grids.
5. Remove three 4mm socket head screws (D) securing the fan grids to the
blower housing. Retain socket head screws and discard fan grids.
SUP22203587
L
I
NSTALLATION
A
1
P
EAF
ROTECTION
I
NSTRUCTIONS
P/N P021005140
C
B
99922203587
05/02
K
IT
D
loading

Resumen de contenidos para Echo PB-650

  • Página 1 ROTECTION NSTALLATION NSTRUCTIONS P/N P021005140 Model: PB-650 S/N: Kit Contents: Upper and Lower Leaf Grids, 7 Brass Collars, 4 Socket head Screws, 4 Flange Nuts Tools Required: 4mm Hex Wrench, 8mm Socket Driver, 20 in. Piece of Starter Rope NOTE All locations are described from the operator point of reference.
  • Página 2: Important

    P/N P021005140 ROTECTION NSTALLATION NSTRUCTIONS 6. Remove two 4mm socket head screws and upper vibration isolator (E) from blower housing. Note the position of the limiter strap for proper reassembly. 7. Assemble the new upper and lower fan grid halves together by snapping the upper fan grid holes onto the lower fan grid buttons.
  • Página 3 UEGO DE PROTECCIÓN DE HOJAS PB-650 N/P P021005140 NSTRUCCIONES DE INSTALACIÓN Modelo: PB-650 N/S: TODOS El juego contiene lo siguiente: Rejillas para hojas superior e inferior, 7 collares de latón, 4 tornillos de cabeza hueca, 4 tuercas de reborde Herramientas requeridas: llave hexagonal de 4 mm, impulsor de manguitos de 8 mm, cordón de arranque...
  • Página 4: Importante

    PB-650 N/P P021005140 I UEGO DE PROTECCIÓN DE HOJAS NSTRUCCIONES DE INSTALACIÓN 6. Quite los dos tornillos de cabeza hueca de 4 mm y el aislador de vibraciones superior (E) de la caja del soplador. Observe la posición de la correa limitadora para el montaje apropiado.
  • Página 5 . P021005140 ÉF ’ NSTRUCTIONS D INSTALLATION Modèle : PB-650 TOUS Contenu du kit : Grilles à feuilles inférieure et supérieure, 7 bagues en laiton, 4 vis à tête creuse, 4 écrous à embase. Outils nécessaires : Clé hexagonale de 4 mm, clé à douille de 8 mm, 50 cm de cordon de lanceur.
  • Página 6 PB-650 K . P021005140 I ’ IT DE PARE FEUILLES ÉF NSTRUCTIONS D INSTALLATION 6. Retirer les deux vis à tête creuse de 4 mm et l’amortisseur de vibrations supérieur (E) du boîtier de la soufflante. Noter la position de la patte de limitation pour la remonter correctement.
  • Página 7 NOTES NOTAS REMARQUES...
  • Página 8 ECHO CONSUMER PRODUCT SUPPORT If you require assistance or have questions concerning the application, CONSUMER PRODUCT operation or maintenance of this product you may call the ECHO Consumer SUPPORT Product Support Department at 1-800-673-1558 from 8:30 am to 4:30 pm 1-800-673-1558 (Central Standard Time) Monday through Friday.

Este manual también es adecuado para:

P021005140