Before Assembly; During Assembly - Palram EZ Link Manual De Instrucciones

EN
Please read these instructions carefully before you start to
assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates that the installer should be inside the product.
Safety
Some parts may have sharp edges. Please be careful when handling
components.
Always wear gloves, eye protection, and long sleeves when assembling
or performing any maintenance on your product.
To prevent injuries, do not allow children to play under the product

during assembly.

Before Assembly

This product is suitable for Palram's Patio Covers range
It is highly recommended to be assisted by a second person in some steps.
Sort the parts and check according to the contents parts list.
Prior to the installation, several parts from the Patio cover needs to be
dismantle, it is recommend to keep them in a safe place for future need.
Periodically check the kit components to assure that it remains stable.
Note: Use only the parts registered in the content list, which are compatible
with your Patio Cover (7999 for Sierra & 7029 for Feria / Tuscany), some parts
may be surplus.
During Assembly
In case that you already own Palram Patio cover it is necessary to
dismantle parts as described in Step 1 in the kit assembly manual.
Option No. 1
Step 1b Sierra: In order to perform this stage, the gutter head must be removed.
Step 4: Select option no. 1 if you would like to mount the supporting poles in
different position than the merged position (using part #7431). Please continue
from this position until step 6. (skip step 7&8) continue to step no. 9.
Step 6: Please make sure that distance from the poles and the kit connection to
original patio cover does not exceed 60 cm.
Option No. 2
Step 4: Select option no. 2 if the setting position of the mounting poles is not
relevant. Please follow from step 7.
Step 7: It is optional to use the existing pole to support the connection
between the new extension and the original patio cover.
In such a case please store the extra pole for future use or dispose properly.
Step 11: Tightening of the bolts is done from inside.
Pay attention: while installing the kit, alignment with original
patio cover is important.
Tighten all screws when completing assembly.