EN
Door Cover
Attention!
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety Advice
• Sort the parts and check against the content list.
• For safety purposes we strongly recommend the product be assembled by two people.
• We strongly recommend the use of work gloves during assembly.
• Do not attempt to assemble the Door Cover in windy or wet conditions.
• Always wear shoes and safety goggles.
• Dispose of all plastic bags safely - keep them out of reach of small children.
• Keep children away from the assembly area.
• Do not attempt to assemble the Door Cover if you are tired, have taken drugs, medication
or alcohol, or if you are prone to dizzy spells.
• When using a stepladder or power tools, make sure that you follow the manufacturers
safety advice.
• Be sure to check that there are no hidden pipes or cables in the wall before drilling.
• Please consult your local authorities if any permits are required to install a Door Cover.
• Before assembly, consider the door's opening (inside or outside).
• Please apply silicone sealant to the rear edge in order to prevent water seepage.
• Tighten all screws when completing assembly.
• Keep roof and gutter clear of snow, dirt & leaves.
• Heavy snow load on roof can damage the product making it unsafe to stand below or
nearby.
Cleaning instructions
• Clean the product once assembly is complete.
• When your Door Cover needs cleaning, use a mild detergent solution and rinse with cold
clean water.
• Do not use acetone, abrasive cleaners or other special detergent to clean the panel.
Additional information:
• The wall anchoring kit supplied with this product is suitable only for concrete walls.
Other wall types need an accordant wall fixation kit.
• Please apply silicone sealant if needed
• You are solely responsible for determining whether the handling, storage, assembly,
installation or use of this product is safe and appropriate in any location or for any given
application. The manufacturer is not responsible for any damages or injury to you, any
other person or any property resulting from the improper handling, storage, installation,
assembly or use of this product, or the failure to follow the manufacturer's written
instructions regarding the handling, storage, installation, assembly and use of this
product. This product is intended for normal residential use only. Do not use this product
for any application that is not recommended in these instructions or building codes in
effect in location where this product will be used. Always take care and use appropriate
safety equipment (including eye protection) when assembling or installing this product.
Before Assembly:
• It is possible to install up to three products joined together.
• Please note: Steps marked with dashed outlines refer to Extensions only.
During Assembly:
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Note: Use only the parts registered in the content list, some parts may be surplus.
Step 1: Important! Please make sure the frame is perfectly centered before fixing.
Step 4: Please apply silicone sealants above beam 8288, in order to prevent water from
seeping in.
Step 20: Please apply silicone sealant on the inner part of 8167 and connect to the profile.