Cosatto NITTY GRITTY SUPA GO Manual Del Usuario página 4

Backrest
Calf support
Basket
Hood
Raincover
Seat cover
Pushchair
Rotate "C" clip to expose its opening (3) and slide waist strap out of clip (4).
Refitting is a reversal of this procedure.
13- Lowering
14- Raising
15- Lowering
16- Raising
17- Removing
18- Fitting
Push the brackets onto the mounts on the chassis (1).
Attach the fabric fasteners to the outside of the seat unit (2).
Fit the rear of the hood behind the backrest and attach the fabric fastener (3).
Attach the straps to the front chassis tubing (4).
19- Opening
20- Extending
21- Using the viewing window flap
22- Removing
Removal is a reversal of step 18 .
23- Fitting
Removal
24-
Release primary lock (1) & secondary folding lock (2).
25-
Release fabric fasteners at rear of backrest (1).
26-
Rotate "C" clip to expose gap (1) and slide waist strap out (2).
27-
Fold retainer flat (1) and push through slot in mounting block (2).
There are three retainers on each side of the pushchair. One on the front chassis
tubing (3) and two on the underside of the seat (4).
28-
Disconnect "C" clip from under seat (1).
29-
Disconnect double "D" ring strap under the calf support (1).
30-
Slide seat cover off calf support end (1) and off the backrest tubing (2).
31- Prior to washing, unzip the top of the backrest section (1) and remove the three
backrest boards (2).
Refitting is a reversal of this procedure.
32- Closing
Ensure backrest is in the upright position 14 .
Always remove the raincover, placing it in the basket and fold the hood completely back.
Pull the ring upwards (1) then press down the secondary lock bar (2).
Push the handles forwards (3) until the auto lock engages (4).