Optional Casters - Uline H-8963 Guia De Inicio Rapido

PAGE 3 OF 9

OPTIONAL CASTERS

Figure 6
Nylon Bushing
Rubber
Expansion Piece
Caster Base
Figure 7
Figure 8
Tube Leg
1-800-295-5510
1. Flip the table back over onto a smooth, non-marring
surface. Remove adjustable feet from tube legs
using a flat head screwdriver. (See Figure 6)
NOTE: A rubber mallet or hammer may be
needed to assist.
2. Hold caster base and rotate nylon bushing
clockwise. This will cause the rubber piece to
expand. (See Figure 7)
3. Expand the rubber enough so that it will fit snugly
into the tube leg.
4. With caster fully inserted into the leg, turn clockwise
until caster is secured to tube leg. (See Figure 8)
NOTE: If too loose, pull out caster and tighten
further. Repeat step 2.
uline.com
0921 IH-8963