Cosatto nitty gritty supa dupa Manual Del Usuario página 6

Fitting & Operation information:
Please refer to the following diagrams:
Pushchair 1-
Brake 2-
3-
Front wheel swivel 4-
lock
5-
Handle 6-
7-
Harness 8-
9-
10-
11-
12-
13-
Footmuff 14-
Backrest 15-
16-
Calf support 17-
18-
Basket 19-
Hood 20-
21-
22-
23-
24-
25-
26-
Drinks Holder 27-
Opening:
Release the auto lock (1) on both sides then pull the handles upward (2).
Press down on the locking lever (3) until a 'Click' is heard and the secondary lock
bar (4) is locked in place.
Check the chassis has locked in place.
Applying:
Releasing:
Applying:
Releasing:
Raising:
Lowering:
Opening:
Closing:
Adjusting the strap
Slide the strap adjustor to suitable length (1, 2 & 3).
Adjusting the shoulder strap
Satisfactory shoulder strap position:
Removing:
Push the shoulder strap retainer through the backrest (1).
Push the crotch strap retainer through the seat (2).
Rotate the "C" clip to expose its opening (3) and slide the waist strap out of clip (4).
Refitting is a reversal of this procedure.
Fitting:
Open the harness 8 and remove chest pad & headhugger (1).
Push the harness straps through the footmuff & headhugger (2).
Attach the footmuff fabric fasteners to the rear of the backrest (3).
Refit chest pads & headhugger then close the harness.
Lowering:
Raising:
Lowering:
Raising:
Removing:
Refitting is a reversal of this procedure.
Fitting:
Fit the hood around the middle handle (1).
Push the brackets onto the mounts on the chassis (2).
Attach the fabric fasteners to the outside of the seat unit (3).
Fit the rear of the hood behind the backrest and attach the fabric fastener (4).
Attach the straps to the front chassis tubing (5).
Opening:
Extending:
Using the hood pocket:
Using the speaker:
Using the multimedia device
Removing:
Removal is a reversal of step 20 .
Fitting:
length:
position:
pocket: