Black and Decker BDCF18 Manual De Instrucciones página 5

Labels on tool
The following pictograms are shown on the tool: :
Warning! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions listed below may result in electric
shock, fire and/or serious injury.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment". p
Do not attempt to charge damaged batteries.
Chargers
Use your BLACK+DECKER charger only to charge the
u
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger. $
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
(Original instructions)
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On / Off button
2. Lens
Fig. A
3. Battery (Not Supplied)
4. Charger (Not Supplied)
5. Charge indicator
Assembly
This product uses the battery and charger listed in
the chart below.
Description
18V Lithium Ion Battery
18V Lithium Ion Battery Charger
Fitting and removing the battery (fig. B)
To fit the battery (3), line it up with the receptacle on the
u
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (6) while at
u
the same time pulling the battery out of the receptacle.
ENGLISH
Catalogue Number
BL1118, BL1318, BL1518, BL2018
905902**, 905998**, 905713**
5