TECshow DERBY LITE Manual De Usuario página 6

Stop and Stop and Start
Start
Flash F_(1~11)
DMX Boot Off
- + Flash Speed
Motor Speed
Notice: Be sure to follow 2 & 3 when making your own
cables. Do not connect the cable´s shield conductor
tto the ground lug or allow the shield conductor
to come in contact whith the XLR´s outer casing.
Grounding the shield could cause a short circuit and
erratic behaviour.
XLR MALE SOCKET
• When longer runs of cable are used, you may
need to use a terminator on the last unit to
avoid erratic behaviour.
• Termination reduces signal transmission
problems and interferance. It is always
advisable to connect a DMX terminal, (resistance
120 Ohm 1/4W) between pin 2 (DMX-) and pin 3
(DMX+) of the last fisture.
P. 6
Tecshow Derby Lite | English version
XLR FEMALE SOCKET
Figure 3
Through this button pause and restart
Automatic flash explosion, through the key - + key blast-
ing flash speed can by adjusted
Through the key into the DMX mode and exit DMXmode
Through this ket to adjust motor rotation speed and the
critical speed
DMX-512 out
3-pin XRL
XLR Pin Configuration
common
Pin 1: Ground
Pin 2: Negative
Pin 3: Positive
Figure 2
DMX-512 in
3-pin XRL