Volkswagen 5G0 052 400 Instrucciones De Montaje página 8

2. Install the 4-core wiring harness:
Detach the luggage compartment cover and the luggage compartment floor covering and remove the
rear body panel trim.
Completely remove the rear bench seat and fold the left and right backrests down.
Remove the luggage compartment trim from the left and right-hand sides of the vehicle.
Remove the C-pillar moulding and roof end strip from the left and right-hand sides of the vehicle.
Remove all tailgate interior cladding.
Remove all of the access trims at the front and rear on the left-hand side of the vehicle (5-door).
Remove all four existing tail lights.
The four existing tail lights may no longer be used on this vehicle after installing the
Only for 3-door vehicles:
Completely remove the left backrest for the rear bench seat.
Remove the left luggage compartment side trim.
In vehicles fitted with an airbag in the side flanks of the backrest it is imperative to pay
attention to the safety precautions when removing and fitting airbag components.
Remove the covers from the left front face of the dash panel.
Remove the bonnet release lever and side trim in the left footwell.
Remove the trims from underneath the onboard supply control unit (BCM).
Remove the covers from the left front face of the dash panel.
Remove the glove compartment and trim elements below the glove compartment.
Open both ends of the left rubber grommet (wire feed-through) between the tailgate and the chassis.
Remove all of the connecting wires on the existing connectors for the four tail lights using a suitable
release tool. First, carefully open the secondary interlock.
The existing connector housings (black & brown) may no longer be used on this vehicle after
11.11.2016-05xxxx
ATTENTION!
4-wire wiring harness!
ATTENTION!
Left-hand drive vehicles:
Right-hand drive vehicles:
Remove the side trim in the left footwell.
ATTENTION!
installing the 4-wire wiring harness!
7 / 70