Technical Data; Protecting The Environment - Stanley FATMAX FME790 Manual De Instrucciones

ENGLISH
The stand compatability test
With the saw mounted on the stand:
Check for fit and function. There shall be no interference
u
of mitre saw throughout the full range of mitre, bevel and
compound cut.
The Work Support can be adjusted to a height that is level
u
with the table top of the mitre saw.
Using the scalable bracket (Fig. H & I)
Use the scalable bracket when working with large work
u
pieces.
Extending the rails
Loosen the locking screw (8).
u
Extend the scalable bracket to the desired position.
u
Tighten the locking screw.
u
When the scalable bracket has been extended to the
u
warning position, it should not be further extended.
Adjusting height of the roller brackets
Loosen the roller bracket adjustment screw at the end of
u
the scalable bracket, as shown in Figure I. Lift the roller
bracket to a height that is level with the table top of the
mitre saw.
Retighten knob and repeat on the opposite side.
u
Warning:
To reduce the risk of injury, make sure the roller
brackets are adjusted so that the workpiece sits flat on the
mitre saw table. Workpieces that do not sit flat could cause the
blade to bind during cutting.
Carry Handle (Fig. J)
A handle (6) has been supplied to transport the mitre saw
stand to and from the work site.
WARNING:
To reduce the risk of personal injury, DO NOT
attempt to store the stand with the saw attached. Loss of
control may result.
Maintenance
Warning:
To reduce the risk of injury, periodically ensure all
fasteners are attached and adjusted according to the
assembly instructions in this manual.
Warning:
When servicing, use only our identical replacement
parts. The use of any other parts may cause a hazard or result
in product damage.
Warning:
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from commercial
solvents and may be damaged by use of solvents. Use clean
cloths to remove dirt, dust, oil, grease, etc.
6
(Original instructions)

Technical Data

Length
Length with bars extended
Height
Maximum working load
Weight

Protecting the environment

Z
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Stanley product needs
replacement, or if it is of no further use to you, do not dispose
of it with household waste. Make this product available for
separate collection.
z
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Stanley Fat Max provides a facility for the collection and
recycling of Stanley Fat Max products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Stanley Fat Max office at the
address indicated in this manual. Alternatively, a list of
authorised Stanley Fat Max repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com
FME790
1120
mm
mm 2148
mm 994
kg 185
kg 14.3