Fixed Panel Installation - Jacuzzi SYDNEY 48 Manual De Instrucciones

1. Insert the fixed panel's bottom seal strip (I) at the base of the fixed glass panel (A), 40mm from the panel's edge.
2. Insert the fixed glass panel (A) into the metal track (B).
3. Slide the sliding door guide (E) onto the bottom of the fixed glass panel (A), but do not secure. Ensure the plastic
gasket in the guide is in place as this protects the fixed glass panel.
Note: The wall track (B) allows you to adjust the position of the fixed glass panel (A). Adjusting the depth and/
or giving the fixed glass panel a slight angle allows for precise alignment with the door.
4-5. Mark the positions of holes of the sliding door guide (E) with a pencil, and drill pilot holes with a ø3mm (1/8in) drill
bit. Then secure sliding door guide (E) with screws (BB) and add the decorative caps (KK).
6-7. Once all adjustments have been made, drill the fixed panel (A) with Φ 3mm (1/8in) in 3 places, secure the wall
track (B) using screws (AA), fittings and caps (FF).
8. Slide the 2 stoppers (M) and the 2 support bar's anchors (N) onto the support bar (D).
9. Loosely mount the support bar (D) onto fixed glass panel (A) using the brackets (II) and level it.
10. Mark the outline of the 2 support bar's anchors (N).
N

FIXED PANEL INSTALLATION

Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
8
D
M
5
KK
A
BB
Φ3mm
1/8in
E
II
A
10
1
A
B
I
3
Φ3mm
1/8in
E
6
AA
FF
9
D
2
A
4
7
A
10
N